User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
5HPRWH0DQDJHPHQW&RQQHFWLRQ
Connect the radio terminal remotely according to one of the
following alternatives:
• For set-up of a TCP/IP network on an Ethernet LAN, refer to
section
&RQQHFWLQJWR(WKHUQHW/$1
below.
• For set-up of a TCP/IP network via a modem, refer to section
&RQQHFWLQJYLD0RGHP
on page 70.
• For set-up of a TCP/IP network via an ECC, refer to section
&RQQHFWLQJYLD(&&
on page 73.
&RQQHFWLQJWR(WKHUQHW/$1
1. Allocate an IP address to the Ethernet port (10baseT) of the
radio terminal in one of the following ways:
– For set-up of a TCP/IP network on an Ethernet LAN using
static IP addresses, allocate a static IP address, subnet
mask and broadcast address to the Ethernet port. Refer to
section
$OORFDWLQJ6WDWLF,3$GGUHVV
on page 78.
– For set-up of a TCP/IP network on an Ethernet LAN using
dynamic IP addresses, configure the Ethernet port to use
dynamic IP addresses. Refer to section
$OORFDWLQJ
'\QDPLF,3$GGUHVV
on page 79.
2. Perform a soft restart of the radio terminal for the changes to
take effect:
– Select
7HUPLQDO
→
6WDWH&RQWURO
and select Restart type
=
6RIW
.
– Wait until the radio terminal is in STANDBY state.
3. Go to the web page "Address Configuration" (
1HWZRUN
→
,3
$GGUHVVHV
) to verify the changes above.