User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
(WKHUQHW7UDIILF3RUWV
Select
7UDIILF
→
(WKHUQHW7,8
and edit the following parameters:
Maximum packet size
6HOHFWWK HPD [LPX PSDFNHW V L]HI R U
WKHSR UWV
Individual port setting: The maximum
packet size is determined by the
"Packet Size" for each individual port
below.
6 kB packet size: The maximum packet
size will be 6 kB. This setting overrides
the "Packet Size" for each individual
port below.
Ethernet VLAN
tagging
6HOHFWLI LWVKRXOGEHSRVVLEOHWRXVH
GLIIHUHQW9/$1,'VIRUWKHSRUWV
Buffer threshold
enabled
6HOHFWLIWKHQXPEHURIEXIIHUV
DOORFDWHGWRHDFKSRUWVKRXOGEH
OLPLWHG
If set to
1R
, "Maximum buffers
allocated", "XOFF threshold", and
"XON threshold" will be ignored.
Maximum buffers
allocated
(QWHUWKH PD[L PXPQ XPE HUR I
EXIIHUV WK DW PD\EH DOO RF DW HG WR
HDFKS RUW
1
Default = 160
XOFF threshold
(QWHUWKHQXPEHURIDOORFDWHG
EXIIHUVWKDWPXVWEHH[FHHGHGWR
DSSO\IORZFRQWUROWRDSRUW
Default = 128