User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
&RQQHFWLQJWKH7UDIILF&KDQQHOV
Select
7UDIILF
→
7UDIILF&KDQQHO
and edit the following
parameters:
3RUWV )XQFWLRQ
Traffic channels from
the TIU. These
correspond to the traffic
ports on the front of the
terminal.
6HOHFWKRZWRFRQQHFWHDFK
WUDIILFFKDQQHO
• Not used: The traffic channel will
not be used for any traffic.
• Connect to MUX: The traffic
channel will be connected to the
MUX and transmitted by this
radio terminal.
• Cross-connect: The traffic
channel will be connected to the
backplane for cross-connection
to another radio terminal
(provided that the radio terminal
is connected to a backplane).