User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
&RQILJXULQJWKH5)&KDQQHO
Select
7UDIILF
→
5)&KDQQHO
and edit the following parameters:
Bandwidth
6HOHFWDEDQGZLGWKYDOXH
RF frame format
6HOHFWDQ5)IUDPHIRUPDW
RF channel no
(QWHUWKH5)FKDQQHOQXPEHURU7;
IUHTXHQF\
TX frequency
(QWHUWKHFRUUHFWWUDQVPLWWHU
IUHTXHQF\RU5)FKDQQHOQR
TX mute
6HOHFW1RUPDOIXQFWLRQ
Output power
(QWHUWKHGHVLUHGRXWSXWSRZHUOHYHO
LQVWHSVRI G%P
≤19 dBm for 37–40 GHz, ≤20 dBm for
21–30 GHz.
Security code
(QWHUWKH FRUUHFWVHFXULW\FRGH
0–255; this number must be the same
for the terminals at both ends of the
hop.
Expected RSL
(QWHUWKHH[SHFWHG5HFHLYHG6LJQDO
/HYHOLQVWHSVRI G%P
The RSL value will correspond to a
maximum ideal AGC voltage level of
3.5 V on the RFU when you align the
antenna.
Use channel filter in
RSL calculation
6HOHFWLIWKH56/VKRXOGEH
FDOFXODWHGDIWHUEDQGSDVVILOWHULQJ
RIWKHUHFHLYHGVLJQDO