User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
1RWH
The Username and the Password are case sensitive.
4. Click
&RQQHFW
.
5. Proceed to section
,QLWLDO5DGLR 7HUPLQDO &RQILJXUDWLRQ
below.
,QLWLDO5DGLR7HUPLQDO&RQILJXUDWLRQ
To get the radio terminal up and running, the minimum
configuration you must perform is as follows:
1. Access the web pages of the radio terminal. Refer to section
$FFHVVLQJWKH:HE3DJHV
on page 60.
2. Supply the radio terminal with system information. Refer to
section
(GLWLQJ6\VWHP,QIRUPDWLRQ
on page 61.
3. Configure the RF channel. Refer to section
&RQILJXULQJWKH
5)&KDQQHO
on page 62.
4. Configure the traffic channels. Refer to section
&RQQHFWLQJ
WKH7UDIILF&KDQQHOV
on page 63.
5. Configure the backplane cross-connections. Refer to section
&URVVFRQQHFWLQJ7UDIILF&KDQQHOV
on page 64.
6. Configure the RF subchannel cross-connections. Refer to
section
&URVVFRQQHFWLQJ5)6XEFKDQQHOV
on page 64.
7. If applicable, configure the Ethernet traffic interface. Refer to
section
(WKHUQHW7UDIILF3RUWV
on page 65.
8. Proceed to section
5HPRWH0DQDJHPHQW&RQQHFWLRQ
on
page 68.