User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
7. Under
&RQQHFWLRQ
, select Data bits =
, Parity =
1RQH
, Stop
bits =
. Make sure that the box
:DLWIRUGLDOWRQH
is
unchecked.
8. Click
$GYDQFHG
. Check
8VHIORZFRQWURO
,
+DUGZDUH576
&76
. Click
2.
. Click
1H[W !
.
9. Leave the text box "Telephone number" empty. If the program
requires that you enter a telephone number, you can enter
any random number. This is of no importance for the function
of the radio terminal modem. Click
1H[W !
.
10.Click
)LQLVK
.
Your PC is now set up for local management and may be
connected to a radio terminal. Proceed to section
&RQQHFWLQJ
'LUHFWO\8VLQJ6WDWLF,3$GGUHVV
below.