User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
10. Select
&20
or equivalent serial port that you want to
connect the modem to. Click
1H[W !
.
11. Click
)LQLVK
.
12. If the dialogue box “Modem properties” does not automatically
appear, double click on the
0RGHP
icon in the Control panel.
13.Click
3URSHUWLHV
.
14. Under
*HQHUDO
, select Max speed =
(other values are
possible, refer to the Operation and Maintenance Manual
(WLDM002)).
15. Under
&RQQHFWLRQ
, select Bits =
, Parity =
1RQH
, Stop bits
=
. Make sure that
:DLWIRUGLDOWRQH
is unchecked.
16.Click
$GYDQFHG
. Uncheck
8VHHUURUFRQWURO
and
8VHIORZ
FRQWURO
.
17.Click
2.
two times.
18.Click
&ORVH
.
19. Restart your computer for the changes to take effect.
20. Proceed to section
&RQILJXULQJ'LDOOLQJ 8S YLD WKH6HULDO 3RUW
below.