User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
/RFDO0DQDJHPHQW&RQQHFWLRQ
Before connecting the radio terminal to local management
equipment, in this case a PC, you must prepare the PC according
to section
6HWWLQJXSWK H 3&
below. When this is done, connect
the radio terminal locally by setting up a point-to-point network
between the radio terminal and the PC using a static IP address.
Refer to section
&RQQHFWLQJ'LUHFWO\8VLQJ6WDWLF,3$GGUHVV
on
page 55.
6HWWLQJXSWKH3&
This section describes how to set up your PC to be able to
connect it locally to any radio terminal. You only have to carry out
the instructions in this section once.
&RQILJXULQJ6HULDO3RUW
You must create a text terminal session with the correct settings
for the serial port that will be used for radio terminal connection.
1. Start the terminal program (HyperTerminal or equivalent) on
your PC. If the program asks if you want to install a modem,
select
1R
.
2. Select
)LOH
→
1HZ&RQQHFWLRQ
.
3. Enter
6HULDO3RUW$05
as the name and select an icon for the
connection.
4. Connect to
&20
or equivalent serial port.
5. The port settings for the serial port should be:
– Bits Per Second (bps) =
(other values are
possible, refer to the Operation and Maintenance Manual
(WLDM002))
– Bits =