User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
6WDWXV/('V
/('VRQWKHFRQWUROSDQHORIWKH%DVHEDQG8QLW
7DEOH%DVHEDQG8QLW/('V
/(' 6WDWH )XQFWLRQ
ACTIVE
1
1. The radio terminal can be in either NORMAL mode or in TEST
mode. The blinking pattern for the ACTIVE LED is the same in
both modes.
OFF The radio terminal is starting up
or reconfiguring (INACTIVE
state).
Blinks 1 Hz The radio terminal is ready to
transmit (STANDBY state).
Blinks 15 Hz The radio terminal is transmitting
(ACTIVE state).
TEST Blinks 15 Hz The radio terminal is in TEST
mode.
WARNING ON
An alarm of severity WARNING
2
has been generated in the radio
terminal.
2. These alarms are software-configurable. For further information,
refer to the Operation and Maintenance manual (WLDM002).
ALARM ON
An alarm of severity ALARM
2
has been generated in the radio
terminal.
Blinks 3 Hz An alarm of severity SEVERE
ALARM
2
has been generated in
the radio terminal.
ESC ALT OK
TEST
ACTIVE
ALARM
WARNING