User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
7DEOH$GGLWLRQDOHTXLSPHQWIRUUHPRWHPDQDJHPHQW(WKHUQHW/$1
FRQQHFWLRQ
7DEOH$GGLWLRQDOHTXLSPHQWIRUUHPRWHPDQDJHPHQWPRGHP
FRQQHFWLRQ
7DEOH$GGLWLRQDOHTXLSPHQWIRUUHPRWHPDQDJHPHQW(&&FRQQHFWLRQ
(TXLSPHQW 'HVFULSWLRQ
TCP/IP-based
LAN
For connection of a remote manager. For further
information, refer to the Operation and
Maintenance manual (WLDM002).
UTP Cable For connection of the radio terminal to an Ethernet
LAN.
If two radio terminals are to be connected to each
other, connect them directly using a null modem
UTP cable (DTE-wired in both ends).
(TXLSPHQW 'HVFULSWLRQ
Modems For placement at the radio terminal site and a
remote manager site respectively. For further
information, refer to the Operation and
Maintenance manual (WLDM002).
Serial Modem
Cable
For connection of a modem to the radio terminal.
The interface in the radio terminal end should be a
9 pin D-SUB jack. The interface in the other end
should fit the serial port of your modem.
(TXLSPHQW 'HVFULSWLRQ
Ethernet E1/DS1
Router
For routing of ECCs to a remote manager. For
further information, refer to the Operation and
Maintenance manual (WLDM002).