User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
(TXLSPHQW5 HTXLUHGIRU&RQILJXUDWLRQ
7DEOH
lists the equipment required for configuration of the
radio terminal on site, i.e. to establish a local management
connection.
7DEOH
–
7DEOH
list additional equipment required to establish
a remote management connection. The required equipment
depends on which type of remote management network you are
going to install the radio terminal in.
7DEOH(TXLSPHQWIRUORFDOPDQDJHPHQWFRQQHFWLRQ
(TXLSPHQW 'HVFULSWLRQ
PC This manual describes how to use a PC with
Windows installed as local manager. Other
platforms can be used, but this is not described.
Windows 95/98 or
NT 4.0 Operating
System
Operating system for PC. Other operating systems
are possible.
Web Browser Used as operator interface. The web browser
could be Netscape Navigator 4.0 or Internet
Explorer 4.0, or later versions.
Text Terminal Used as operator interface to send commands
directly to the Management Information Base via
RS-232 serial interface. The text terminal could be
HyperTerminal, which is usually included in
Windows, or equivalent.
Dial Up
Networking
Software
Used for dialling up via the serial port. This
software is included in Windows but not always
installed by default.
The file "amr.inf" Supplied by Allgon AB on the disc marked "AMR
Software".
Serial PC Cable For connection of the PC to the radio terminal. The
interface in the radio terminal end should be a
9 pin D-SUB plug. The interface in the other end
should fit the serial port of your PC (e.g. COM1).