User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
2XWGRRU,QVWDOODWLRQ
WLDM001B
2. Connect the outdoor radio cable to the RFU and the adapter
between the indoor and outdoor radio cable.
*URXQGLQJWKH5DGLR&DEOH
It is recommended to ground the radio cable every 50 m along the
mast, at the foot of the mast and before entering a building.
If a surge arrester is mounted in the wall, it should be mounted in
a copper plate with a low resistance connection (< 0.1 Ω) to
ground on the outside. This will protect the indoor equipment in
case of lightning strikes.
5HFRPPHQGHGJURXQGLQJRIWKHUDGLRFDEOH