User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
2XWGRRU,QVWDOODWLRQ
WLDM001B
0RXQWLQJWKH,QWHJUDWHG$QWHQQD5DGLR
)UHTXHQF\8QLW
0VFUHZVXVHGIRUPRXQWLQJWKHLQWHJUDWHG$QWHQQD5DGLR
)UHTXHQF\8QLW
1. Mount the integrated Antenna/RF Unit on the Mast Mounting
Bracket by inserting the two M10 screws in the dedicated
slots.
2. Use the 17 mm torque wrench to tighten the two M10 screws.
1RWH
The torque must be 35 Nm ± 10% when tightening
the M10 screws!