User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
2XWGRRU,QVWDOODWLRQ
WLDM001B
4. Use the 17 mm wrench to fasten the RFU by turning the
locking screw on the bottom of the antenna 1/4 turn. You will
feel a gentle click when the RFU is locked in position. Stop
turning when you feel the resistance increasing.
&KRRVLQJ/HIWRU5LJKW6LGH$QWHQQD0RXQWLQJ
0RXQWLQJWKH0VFUHZVRQWKHDQWHQQD
Two M10 screws are used for fastening the Antenna/RF Unit on
the Mast Mounting Bracket. They can be mounted on either side
of the antenna.
• Make sure that the screws are placed in the screw holes on
the correct side of the Antenna Unit, and that there is enough
space to allow mounting of the Antenna/RF Unit to the Mast
Mounting Bracket.
&$87,21
'RQRWFRQWLQXHWXUQLQJWKHORFNLQJVFUHZZKHQ\RXIHHO
WKHUHVLVWDQFHLQFUHDVLQJ
&$87,21
:KHQ\RXFDUU\ RUOLIWWKH$QWHQQD5)8QLWXVHWKHKDQGOH
RQWKHWRSRIWKHDQWHQQD7KHKDQGOHRQWKHEDFNRIWKH
5)8LVQRWLQWHQGHGIRUWKLVSXUSRVH