User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
2XWGRRU,QVWDOODWLRQ
WLDM001B
,QWHJUDWLQJ$QWHQQD8QLWDQG5DGLR)UHTXHQF\
8QLW
1. Remove the plastic covers for moisture protection from the
waveguides on the RFU and the Antenna Unit.
,QWHJUDWLQJWKH$QWHQQD8QLWDQGWKH5DGLR)UHTXHQF\8QLW
2. Hook the circular part of the RFU, containing the waveguide,
onto the locking device on the back of the Antenna Unit.
1RWH
The direction of the handle on the RFU must be in
accordance with the desired polarization! Make sure
that the coaxial connector on the back of the RFU fits
the connector on the back of the Antenna Unit!
3. Gently push the RFU as far as it can go into the Antenna Unit.
&$87,21
$IWHUWKH SODVWLFFRYHUVKDYHEHHQUHPRYHG PDNHVXUH WKDW
QRPRLVWXUHHQWHUVWKHZDYHJXLGHV