User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
2XWGRRU,QVWDOODWLRQ
WLDM001B
&KRRVLQJ9HUWLFDORU+RUL]RQWD O3RODUL]DWLRQ
The position of the RFU determines the polarization of the radio
signal. The handle serves as an indicator: horizontal handle =
horizontal polarization, vertical handle = vertical polarization.
The coaxial connector on the back of the Antenna Unit must fit
the connector on the RFU. Use a Pozidrive screwdriver PZ2 if
you need to move the connector on the Antenna Unit.
1RWH
Do not remove the screw or the washer when you move
the connector.
3RVLWLRQRIFR D[ LD OFRQ QH FWRU IR UYH UW LFDOS RODU L]DWLRQ
3RVLWLRQRIFR D[ LD OFRQ QH FWRU IR UK RU L]RQWDOS RODU L]DWLRQ
&$87,21
)RUKRUL]RQW DO SROD UL]DWL RQ PDNHVX UHWKD WWKH FRD[ LDO FDEOH
UXQVLQWKHGHGLFDWHGVORWRQWKHEDFNRIWKH$QWHQQD8QLW