User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
,QGRRU,QVWDOODWLRQ
WLDM001B
,QVWDOOLQJWKH&DEOHVIRUWKH,QGRRU8QLW
1RWH
The connector manufacturer’s instructions for mounting
of the connectors must always be followed!
'HILQLWLRQRI7;DQG5;6LJQDOV
7;
signals are defined as signals coming
RXWRI
the TIU.
5;
signals are defined as signals going
LQWR
the TIU.
8QEDODQFHG7UDIILF,QWHUIDFH60=&RQQHFWRUV
Mount the SMZ connectors on the cables and connect the cables
to the Indoor Unit. The channel number and the direction (TX/RX)
for each SMZ connector are indicated on the TIU.
%DODQFHG7UDIILF,QWHUIDFH'68%&RQQHFWRUV
Mount the connectors on the cables according to the pin
allocation listed in the tables below and connect the cables to the
Indoor Unit.
1RWH
The cables for the balanced traffic interface must be of
type shielded twisted pair!