User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
,QGRRU,QVWDOODWLRQ
WLDM001B
8QEDODQFHG,QWHUIDFHV
7UDIILF,QWHUIDFH8QLWXQEDODQFHGLQWHUIDFH((
7DEOH 7UDIILF,QWHUIDFH8QLWXQEDODQFHGLQWHUIDFH((
3RV &RQQHFWRU )XQFWLRQ
1 9 pin D-SUB Traffic Channel (E1:17)
2SMZ
Traffic Channel (E3:1), outgoing direction (TX)
1
1. The channel number and the direction (TX/RX) for the SMZ connectors are
indicated on the TIU.
3SMZ
Traffic Channel (E3:1), incoming direction (RX)
1
4 9 pin D-SUB Overhead Channel (OH:1)
5 9 pin D-SUB Overhead Channel (OH:2)