User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
,QGRRU,QVWDOODWLRQ
WLDM001B
%DVHEDQG8QLW
,QWHUIDFHVRQWKH%DVHEDQG8QLW
7DEOH %DVHEDQG8QLWLQWHUIDFHV
3RV ,QWHUIDFH )XQFWLRQ
1 User interface Control panel with keypad and display for
configuring the radio terminal without a PC,
and status LEDs for monitoring of the radio
terminal. For further information about the
control panel, refer to the Operation and
Maintenance Manual (WLDM002).
2 9 pin D-SUB jack LM/NMS 1 port, used for connecting a PC
or for daisy-chaining radio terminals. The
interface standard is RS-232/DCE.
3 9 pin D-SUB plug MODEM/NMS 2, used for modem
connection or for daisy-chaining radio
terminals. The interface standard is RS-
232/DTE.
4 TNC jack Used for connection to the RFU.
5 M6 grounding lug Used for grounding of the Indoor Unit.
6 2 pin D-SUB plug DC power connector.
7 26 pin D-SUB
High Density jack
External I/O port, used for monitoring and
control of external functions, and for status/
alarm reporting.
8 RJ-45 jack 10baseT Ethernet port, used for connection
to a LAN. The interface standard is
Ethernet/DTE.