User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6LWH5HTXLUHPHQWV
WLDM001B
2XWGRRU5HTX LUHPHQWV
2XWGRRU6SDFH5HTXLUHPHQWV
The standard method for mounting the Radio Frequency Unit
(RFU) and the Antenna Unit is to mount them together as one
integrated unit.
7DEOH 6SDFHUHTXLUHPHQWVIRUWKHLQWHJUDWHG5DGLR$QWHQQD8QLW
0DVW5HTXLUHPHQWV
7DEOH 5HTXLUHPHQWVIRUDQWHQQDPDVW
$QWHQQD8QLW $ % & ' (
1 ft. HP antenna 300 mm 380 mm 390 mm 125 mm 165 mm
2 ft. HP antenna 390 mm 635 mm 520 mm 125 mm 165 mm
5HTXLUHPHQW 9DOXH
Mounting pole diameter 40–130 mm
Mast stability: variation in direction of
antenna
≤ 0.25°