User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6LWH5HTXLUHPHQWV
WLDM001B
,QGRRU5HTXLUHPHQWV
,QGRRU6SDFH5HTXLUHPHQWV
7DEOH 6SDFHUHTXLUHPHQWVIRUWKH,QGRRU8QLW
All interfaces are accessible on the front of the Indoor Unit.
,QVWDOODWLRQ : + ' )
1. Space required for connecting cables and connectors.
Single Indoor Unit 19" 1U 270 mm 70 mm
2U Magazine 19" 2U
290
2
mm
2. The units will extend an additional 20 mm in front of the rack,
compared to Single Indoor Unit mounting.
70 mm
6U Magazine 19" 6U
290
2
mm
70 mm