User's Manual

ID Alarm Text OMS
Ceasing
Alarm Unit Alarm Level Description
55 R2R queue full No BSC None The R2R transmitting queue is full and messages are lost.
Suggested remedy: Check the R2R configuration and cables.
56
R2R node lost No BSC None An R2R node is lost.
Suggested remedy: Check if the node is still operating and
connected.
57 R2R HW error No BSC Error R2R hardware fault.
Suggested remedy: Replace the repeater.
70 Bad table found No BSC Error A requested table contains information error (software error).
71 Table not found No BSC Error A requested table was not found in the database (software or
calibration error).
72
Table database
err
No BSC Error The database table is not found (calibration error).
121 Synthesizer fault Yes BSC UL/DL Error Unlocked synthesizer.
The frequency synthesizer is unlocked and the transmission can
take place on unknown frequency.
122 Volt Reg fault Yes BSC UL/DL Error A DC voltage to an analog part of the board is missing.
123 PA fault Yes BSC UL/DL Error Low power amplifier gain.
The PA has too low output power for the RSSI and gain set.
Not available in all BSC software versions.
125
High temperature No BSC UL/DL Warning The BSC board temperature is higher than 85°C.
Error The BSC board temperature is higher than 95°C and the power
is turned off.
Ceasing The temperature has fallen to below 70°C and the power is
turned on again.
126 High PSU
voltage
Yes BSC UL/DL Critical The PA supply voltage is too high.
Suggested remedy: Ensure that correct PSM is used.
Remarks
The Mains breakdown alarm (3) requires a relay not included in the repeater.
The Door open alarm (20) requires an optional door switch.
The Battery backup fault alarm (48) requires an optional battery backup unit.
The Fiber optical error alarm (50) requires an optional fiber optical interface.
ALLGON Systems AB ALR Compact Repeater Repeater Alarms
VD203 67/EN - User’s Manual Rev. 1A 2000-07 7 - 5