User Manual
Table Of Contents
- Front Page
- Preface
- Contents
- Figures
- Abbreviations
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description and Design
- 6. Optionals
- 7. Repeater Alarms
- Index
- Questionnaire
Not used RCC unit: 5. This step is applicable only if the repeater has an RCC unit which is
not used (or has been removed).
If the P130 cable connector has been removed, then pin 1 and 2 of the
P130 port must be interconnected with a jumper. Do not interconnect
any other position than between pin 1 and 2 of the P130 port.
The jumper is found in the P113 parking device if not used in the
P130 port.
The P130 port is described on page 3-12 and the P113 parking device
is described on page 3-10.
6. Set up a PC with OMT32 to the repeater by connecting a standard
RS-232 serial cable between a COM port on the PC and the P112 PC
port located to the right in the repeater cabinet (see Figure 3-7 on
page 3-9).
Port P112 is described on page 3-10.
Now, you can commission the repeater as described in Chapter 4.
ANT
HI LO
ANT
LO
HI
P112
ALLGON Systems AB ALR Compact Repeater Installation
VD203 67/EN - User’s Manual Rev. 1A 2000-07 3 - 8