User Manual
Table Of Contents
- Front Page
- Preface
- Contents
- Figures
- Abbreviations
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description and Design
- 6. Optionals
- 7. Repeater Alarms
- Index
- Questionnaire
Mounting
The ALR repeater is easy to mount, either by anchoring the repeater in
the fixing holes, or by using the EA101 57/1 Pole Mounting Bracket kit,
containing a mounting bracket, clamps for 40mm – 110mm round pole,
and fixing screws for fastening the repeater to the mounting bracket.
The mounting bracket is shown in the figure. The holes are threaded
(M6) and correspond to the mounting holes in the repeater.
1. Mount the repeater.
Normally, the repeater is mounted on a wall, pole, or mast. These
mounting cases are shown below.
Figure 3-2 shows how to mount the repeater to a wall using four
fixing screws. You can use screws for maximum 13mm (1/2") hexagon
socket wrench, e.g. 6mm (1/4") bults.
ANT
HI LO
ANT
LO
HI
Figure 3-2. Attaching the repeater to a wall
ALLGON Systems AB ALR Compact Repeater Installation
VD203 67/EN - User’s Manual Rev. 1A 2000-07 3 - 3