User Manual

3. Connect external alarm sensors (burglary, fire, etc.) and other
external alarm equipment (optical or acoustic signal, etc.), if any.
Cables for this installation is taken through a free strain relief
bushing on the bottom of the repeater, in the same way as the mains
cable and the antenna cables.
External alarm is connected to the P119 alarm port located in the
centra in the cabinet (see Figure 3-7 on page 3-9). Use a 7 pole male
connector.
The P119 port is described on page 3-11.
This is a schematic figure of
the various RCC parts.
4. Connect the internal phone/modem unit for remote control of the
repeater, if any.
The modem and a power backup unit are integrated in an RCC,
Remote Control unit for Compact repeater, which is mounted to the
right inside the cabinet and connencted to the P130 port located to
the right in the cabinet (see Figure 3-7 on page 3-9).
The RCC is also powered by the P130 port.
The mobile phone antenna is connected to the BS antenna via an
uplink combiner located at the RCC unit to the right in the cabinet,
provided that the phone and the repeater operate in the same system.
Pin 1 and 2 of the P130 port are interconnected with a jumper if no
RCC is used. This jumper must be removed before plugging the RCC
connector to the P130 port.
If the RCC is removed, the jumper between pin 1 and 2 on the P130
port must be reconnected. Otherwise, a part of the circuitry will have
no voltage supply. Do not connect the jumper to another position than
between pin 1 and 2 on the P130 port.
The P130 port is described on page 3-12.
5. Connect a telephone line for remote control of the repeater, if any.
The telephone line is connected to a modem, which is connected to
the P130 modem port on the repeater.
The P130 port is described on page 3-12.
Use a free strain relief bushing at the bottom of the repeater for the
external telephone line cable.
ANT
HI LO
ANT
LO
HI
External
alarm sensors
ANT
HI LO
ANT
LO
HI
RCC
Modem
Battery
Power supply
ANT
HI LO
ANT
LO
HI
Telephone line
Modem
ALLGON Systems AB ALR Compact Repeater Installation
VD203 67/EN - User’s Manual Rev. P1D 2000-05 3 - 7