User's Manual

Figure 3:
Wall mounting
• Attach the TTPA to the mounting plate according to the figure below. When the
TTPA has been mounted on the plate, press it downwards until it sticks. Tighten
the two bottom nuts.
Figure 4: Attaching the TTPA to the mounting plate
• Ground the unit through a grounding strap, mounted to the ground screw and a
ground connection on the pole or mast, or to the ground cable between antenna and
earth.
Phase 2:
The second phase of the installation, that is the attachment of cables between
antenna and TTPA, and TTPA and BTS, must be carried out with the BTS shut
down.
• Shut down the BTS.
• Attach the cable between antenna and TTPA, and between TTPA and BTS.
Often there is a low loss feeder between the BTS and the antenna, with the feeder
attached to the antenna using an adapter cable. If this is the case, it may be easier