User's Manual

Figure 1: Mounting plate
• Attach the mounting plate for the TTPA to the wall or the mounting pole. Use the
clamps or screws and plastic plugs provided with the unit. The cable connectors of
the unit must be on the bottom side of the unit. Tilt must not exceed 10 degrees.
Pole mounting: Note that the inner nut (with a flange) is kept in position while it
is locked by the outer nut.
Wall mounting
: Note that the holes shall be 10 mm in diameter, and about 60 mm
deep, and that the plastic plugs included in the mounting kit shall be used.
Figure 2: Pole mounting