User's Manual

MCPA Removal and Replacement G3L-2129-140 MCPA
4-2 044-05369 Rev A
MCPA Removal and Replacement
Perform the instructions in Table 4-3 to remove and replace a MCPA.
CAUTION: Do not slam the MCPA into the system during installation. Using excessive force can
damage the MCPA connector.
CAUTION: When removing the MCPA from the system, support the MCPA to prevent the rear of
the MCPA from suddenly dropping when the guide rail disengages from the track. Dropping the
MCPA can damage the rear multi-pin connector. The MCPA weighs approximately 28.60 lbs.
(12.97 kg).
Return For Service Procedures
When returning products to Powerwave, the following procedures will ensure optimum response.
Obtaining An RMA
A Return Material Authorization (RMA) number must be obtained prior to returning equipment and to reduce
delays in receiving repair service. Please contact our Repair Department at [phone] to obtain this
number, or FAX your request to [phone].
Repackaging for Shipment
To ensure safe shipment of a component, it is recommended that the original packing materials be reused If
this is not possible, use suitable shipping cartons and foam inserts to prevent damage in transit.
Table 4-3 MCPA Removal and Replacement
Step Action
1 Set MCPA OFF/ON/RESET switch to OFF (down).
2 Loosen two quarter-turn fasteners that secure MCPA to the subrack.
3 With steady even pressure, use handle on front of the MCPA to pull the MCPA out of the
system.
4 To replace MCPA, set MCPA OFF/ON/RESET switch to OFF (down).
5 Turn quarter-turn fasteners to Unlocked position.
6 Insert MCPA into subrack. Turn quarter-turn fasteners to locked position to secure MCPA.
DRAFT