User's Manual

Connectors Nexus RT
2-2 044-05311 Rev A
Connectors
Figure 2-2 and Table 2-2 describe the connectors available on the Nexus RT repeater.
Figure 2-2 Nexus RT Connectors
CAUTION: All connectors are located on the bottom face of the repeater.To avoid damaging the connec-
tors, do not set the set the repeater down on the connector side.
Software and Hardware Compatibility
There are different versions of Contol Unit (CU) Printed Circuit Board Assembly (PCBA) software which can
be combined with PCBAs of various revisions. These have unique part numbers and revision information.
Table 2-3 lists the software currently available in combination with CU PCBA revisions.
Table 2-3 Hardware / Software Compatibility
This information is accurate as of 06/31/2007. As new versions of hardware and software are released without
prior notice, contact your Powerwave sales representative for information on the latest revision.
For detailed information, refer to the release notes for the CU software to be downloaded (normally found in
the readme.txt file provided with the program files).
Table 2-2 Nexus RT Connectors
Connector Type Purpose
DNR ANT 850 MHz
SRV ANT 850 MHz
Type N Female Connectors for receive/transmit signals in 850 MHz
DNR ANT 1900 MHz
SRV ANT 1900 MHz
Type N Female Connectors for receive/transmit signals in 1900 MHz
POWER Circular DIN Main power connector
LOCAL and WAN RJ-45 Connectors for repeater control and status
RS-232 Circular DIN Factory use only
ALARM Circular DIN Connector for alarm signals external to the repeater
CU PCBA part number CU Software part number
500-13817-001 (previously K103/3) D631-18072-001
D631-18072-003