User's Manual Part 3

Alarm Functions OS-1933-E3-003

044-05243 Rev A 3-17

Ethernet Web Page Procedure

Ethernet Interface (rear panel)

This port is intended for control and monitoring by a BTS or Remote Network Management System on a

permanent basis.

Form-C / External Alarm Interface (rear panel)

Reference the Form-C and External Alarm interface section in chapter 2 for pin-outs and installation.

Form-C Alarms

The alarm status is reported via Form-C contacts. There are five Form-C alarms: ALARM1 through ALARM5.

The alarms are detailed as follows:

Alarm 1

Minor Alarm - all sectors:

• Any cabinet fan fault.

• Intrusion – if one or both booster doors are opened.

• Rectifier Communication Fault.

Alarm 2

A Major Alarm - all sectors:

• TMA1 or TMA2 is faulted (if both enabled), but not both faulted.

• TMA3 or TMA4 is faulted (if both enabled), but not both faulted.

• TMA5 or TMA6 is faulted (if both enabled), but not both faulted.

• LNA1 or LNA2 is faulted, but not both faulted.

• LNA3 or LNA4 is faulted, but not both faulted.

• LNA5 or LNA6 is faulted, but not both faulted.

• Any rectifier fault.

• Any External Alarm fault.

• No communication from the MODEM (if applicable).

Table 3-15 Ethernet Web Procedure

Step Action

Connect Ethernet crossover cable from PC to modem front panel ETHERNET connector.

Boot up PC.

On PC, go to Start-Settings-Control Panel Network Connections. Right click on Local Area Connection,

then select Properties.

After Local Area Connection Properties window opens, deselect all functions except Internet Protocol

(TCP/IP).

Double click on Internet Protocol (TCP/IP) to open Internet Protocol (TCP/IP) Properties window.

Select “Use the following IP address”.

At “IP address” type in 192.168.0.2, then press Tab key. Subnet mask fills in 255.255.255.0. Select OK to

close window.

Select OK to close Local Area Connection Properties window.

Open Internet Explorer.

Using Internet Explorer Address bar, type http://192.168.0.1, then press Enter key. The Powerwave

Twoport application is enabled and Log In screen is displayed.