User's Manual Part 2

OS-1933-E3-003 Field Replaceable Parts and Modules
4-6 044-05243 Rev A
Rectifier Module Removal and Replacement
Perform the instructions in Table 4-5 to remove and replace the rectifier module shown in Figure 4-2
CAUTION: The rectifier module weighs approximately 5 lbs. (2.3 kg). When removing the rectifier module from
the subrack, support it at the rear when the guide rail disengages from the track to avoid dropping the module.
Dropping the rectifier module could damage the rear multi-pin connector.
Table 4-5 Controller Module Removal and Replacement Procedures
Step Action
1
Using a #2 Phillips screwdriver, loosen the Phillips fastener securing the latch.
2 Slide and hold latch to left
3 Use handle to carefully pull rectifier module out of cabinet
4 Replace rectifier by carefully sliding rectifier into empty slot until rectifier is secured
Figure 4-2 Rectifier Removal and Replacement
Rectifier
Latch