User's Manual

Connections Nexus FT Strand Mount

3-2 044-05320 Rev A

Connections

This section describes general examples of how to connect the input and output ports on the WRH.

Main Power and Grounding

Local regulations need to be followed for the main power connection. Nexus FT SMs are approved in

accordance with EN and UL/cUL regulations. This is, however, only valid if a classified power cord is used.

For the Nexus FT SM to meet these regulations you must select one of the following classified and approved

cord types:

❑ EN – H 05 W5 - F HMR

❑ UL – AWM Style 2587

❑ CSA– AWM 1 A/B 11 A/B

For outdoor use, the power cord should meet at least IP65 encapsulation requirements. Do not turn the main

power on until you are ready to commission the WRH.

Fiber Optic and RF Connections

Fiber optic and RF cable connections should be verified both internally and externally before powering up the

equipment. This section illustrates the general internal connections of the Nexus FT SM. Verify these

connections with the as-built drawings and documents for your specific system configuration. Table 3-1 lists

the steps to add the external connections to the Nexus FT SM.

Table 3-1 Cable Connection Procedure

WARNING: For Nexus FT SMs supplied from the main power source, the main outlet must be

grounded.

Step Action

DRAFT