User's Manual
Table Of Contents
- High Power
- Wideband Radio Head (WRH-V)
- Table of Contents
- Chapter 1 - Product Description
- Chapter 2 - Controls, Indicators and Connectors
- Chapter 3 - Installation
- Chapter 4 - Maintenance
- Chapter 5 - Specifications
- Appendix A - Block Diagrams
- Chapter 1 Product Description
- Introduction
- Scope of Manual
- Safety
- Overview
- Figure 1-1 Powerwave Wideband Radio Head (WRH)
- Chassis Design
- Wideband Amplifier PCBA (WBA)
- Multi-Carrier Power Amplifier PCBA (MCPA)
- Distribution PCBA (DIA)
- Figure 1-2 DIA PCBA
- Control Unit PCBA (CU)
- Figure 1-3 CU PCBA
- Low Noise Amplifier (LNA)
- Figure 1-4 LNA
- Duplex Filter (DPX)
- Fiber Optic Unit (FOU)
- Figure 1-5 FOU in WRH-V
- Fiber Optic Node (FON)
- Power Supply Unit (PSU)
- Remote Control Unit (RCU)
- Alarm Interface PCBA (ALI) and Remote Control Interface PCBA (RCI)
- Figure 1-6 WRH-V Sub Unit Locations
- Figure 1-7 Fiber Optic Star Configuration
- Figure 1-8 Multi-operator System
- Chapter 2 Controls, Indicators and Connectors
- Chapter 3 Installation
- Chapter 4 Maintenance
- Chapter 5 Specifications
- Appendix A Block Diagrams
Mounting High Power Wideband Radio Head (WRH-V)
3-2 044-05251 Rev A
Figure 3-1 Mounting Bracket
Normally, the WRH-V is mounted on a wall, pole, or mast. Figure 3-2 illustrates the installation of the
mounting bracket on a wall using four fixing screws and a locking screw.
Figure 3-2 Mounting Bracket Installation on Wall
Figure 3-3 illustrates the installation of the mounting bracket on a pole using two 5.7-inch (144mm) U-shaped
clamps and a locking screw.
90
135
144
205
250
300
Ø14
A
411