User's Manual

PCBA Connections AR Standard Repeater
044-05250 Rev A 2-11
Table 2-12 FON Connectors
Port Type Description
P101 SMA Electrical RF input port (to the optical TX port)
P102 SMA Electrical RF output port (from the optical RX port)
P103 SMA Electrical RF output port (15dB below the P102 port)
RX DIN/APC Optical input port (to the P102 and P103 RF ports)
TX DIN/APC Optical output port (from the P101 RF port)
P104 Used only for development and debugging
P105 4 pin male Door LED indicators. Used for the yellow and red LED indica-
tors located on the front cabinet door
P106 9 pin D-sub
female
RS-232 used for local PC communication
P108
P116
6 pin male Parallel connected power ports for the FON
P109 7 pin male Used for external alarm sensors
P110 W-link
jumper
Used to terminate units in a W-link. It has to be set in the
parking state for all units except for the first and last units in a
W-link. The Parking state (P) has the jumper between the
center and bottom pins. The opposite state (T) terminates the
W-link.
P111
P112
5 pin male WLI ports used for interconnecting nodes in WLI-nets (IP or
R2R networks). They are identical and connected in parallel.
One of the connectors are intended to be used from the previ-
ous node and the other connector to the next node in the net-
work. Either can be used for the first and last unit in the net
chain.
P113 2 pin male Batteries - used for the on-PCBA backup batteries.
P114 Backup
power out-
put jumper
Sets the backup power output state. The OFF state has
jumper between the center and left pins. This jumper has to
be in the OFF state when used in an OCM. Otherwise, it shall
be in the ON state.
P115 3 pin male Future port - intended for future use
P130 34 pin, 2 line
male
RCU port used for connecting an RCU. The connector con-
tains both the modem connection and RCU power supply.