Installation Guide

2
. Installation
Before installation, read carefully Chapter 1, Safety.
Siting the Repeater
Allgon repeaters are designed for outdoor usage. However, humidity and
temperature changes may have affect on the reliability. A preferable site
for the repeater is thus indoor, in a tempered and ventilated room.
Sunshine
If a repeater is placed outdoor and can be exposed to direct sunshine, it is
essential that the air can circulate around the repeater with no obstacle.
The operating temperature must not exceed +55°C. A shelter can be used
to shade the repeater from direct sunshine.
Shelter
Allgon repeaters are designed with a weather proof outdoor case that can
be mounted without any kind of shelter from rain, snow or hail.
If a repeater is to be opened on the site when raining, snowing, or hailing
there must be some kind of permanent or temporary shelter. This is
applicable to gentle rainfall, snowfall or hail. Limitations for very bad
weather is found in the next section.
Allgon can provide a shelter designed for these repeaters. This shelter is
shown in Figure 2-1.
Outdoor Installation and Service Limitations
Sited outdoors, the repeater must not be opened for installation or service
at bad weather, such as:
– Intense rainfall, snowfall or hail.
– Storm or high wind.
– Extremely low or high temperature.
– High humidity of the air.
Allgon Systems AB AR Repeaters Installation
VD204 43/EN - Installation Guide Rev. 1A 2001-06 2 - 1