Installation Guide

• A lithium battery is permanently mounted on the CU and FON boards.
Due to the risk of explosion, this battery must not be removed from the
board. In case of battery malfunction, replace the entire board. The
old board can be sent to Allgon for repair.
• The optional FON board contains a class 1 laser transmitter that emits
invisible laser radiation during operation. Avoid direct exposure from
unconnected laser transmitter or fiber cord.
• The heat sink element on a CDMA High Power repeater can be very
hot. Do not touch this surface during operation.
Warning Signs
The following warning signs must be observed and be kept clean and
readable.
Beryllium oxide
This warning sign is applied on boards and units which contain beryllium
oxide parts.
This warning sign is applied at the bottom, inside the cabinet, below the
power supply unit.
The previous section details parts containing beryllium oxide and how to
avoid dangerous dealing with these parts.
Beryllium
oxide
hazard
BERYLLIUM OXIDE
(Toxic)
used in equipment
see instruction book
Allgon Systems AB AR Repeaters Safety
VD204 43/EN - Installation Guide Rev. 1A 2001-06 1 - 2