Installation Guide

2. After attaching the bracket, hang the repeater on the upper supports
(see Figure 2-6) and use the screws for the lower ones. Tighten the
upper and lower screws.
There are locking cylinders that can be inserted and locked with a
key after the lower screws have been tightened (see Figure 2-6).
These prevents from unauthorized removal of the repeater.
3. Make sure the donor antenna, directed towards the base station
antenna, is mounted.
4. Make sure the service antenna, directed towards the area to be
covered by the repeater, is mounted.
Figure 2-6. Attaching the repeater to the bracket
Allgon Systems AB AR Repeaters Installation
VD204 43/EN - Installation Guide Rev. 1A 2001-06 2 - 6