User's Manual

Normal Operation
2.5 Normal Operation
The LNKF100 Module has six LED’s on the faceplate:
OPERATING - LED will flash GREEN when RF Data is present and unit
is operating normally.
STANDBY – Under the control of the Control Module, the LNKF100
Module has the ability to act as a duplex transmitter, sitting perpetually in
stand by mode waiting for the primary transmitter to fail. This LED should
be constant Amber. If a fault should occur with the primary module, the
“Stand by” unit will immediately become the primary unit, at which time
the stand by LED will be turned off and the LED’s will show an operating
module.
TRANSMIT – Green when a signal is being transmitted.
RECEIVE – Green when a signal is being received.
PROGRAM – Constant Amber when the unit is being re-programmed by
the controller module. This will signify that the unit is powered on but
unavailable for use.
FAULT – Constant Red if the internal diagnostics for the module detects a
problem.
Figure 2-1 LNKF100 Faceplate
D044-13432 Rev A 7