Manualshelf

User's Manual

ManualsBrandsPowerwave Technologies ManualsElectronicsLINKNET UNISERV UNIT BOOSTER
18192021222324252627
DCM000000104 Rev Q
6-1
Chapter 6
Antenna Installation
6 Introduction
This chapter contains antenna installation and warning information for the LinkNet Uniserv Unit
RF-FIBER Interface Modules.
6.1 Antenna Installation
•
All Antenna installation to be performed by qualified technical personnel only.
• Antenna installation instructions and locations below are for the purpose of satisfying
FCC RF Exposure Compliance requirements.
• The In-Building Antenna or Antennae connection is via a coaxial cable distribution system
connected to the fixed-mounted
Indoor Antennae
. The
Indoor Antennae
are simple 1/4
wavelength (0 dB Gain) types. These antennae are to be installed such that no person
can touch the antenna, or approach within 0.2 Meters.
ANTENNA INSTALLATION
CAUTION
ALL ANTENNA INSTALLATION IS TO BE PERFORMED BY QUALIFIED TECHNICAL PERSONNEL
ONLY.
ANTENNA INSTALLATION INSTRUCTIONS AND LOCATIONS ARE FOR THE PURPOSE OF
SATISFYING FCC RF EXPOSURE COMPLIANCE REQUIREMENTS, AND ARE NOT OPTIONAL.
ALL IN-BUILDING ANTENNAE INSTALLATIONS MUST BE SUCH THAT NO PERSON CAN TOUCH
THE ANTENNAE, OR APPROACH CLOSER THAN 0.2 METERS.
Please consult Powerwave Technologies Inc. for assistance as required.
6.2 FCC Information to Users
•
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAUTION
CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY POWERWAVE
TECHNOLOGIES INC. COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.