User's Manual

Fiber Optics Powerwave

3 - 10 Rev. P1A9-Draft 2004-11 VM100 56/EN – User’s Manual

P110 – W-link jumper

This jumper is used to terminate units in a W-link. It has to be set in the parking state for

all units except for the first and last units in a W-link.

Parking state is shown in the figure (the pins farest away from the battery pack

interconnected).

The opposite state terminates the W-link.

P111, P112 – WLI ports

P111 and P112 are 5 pole male connectors used for interconnecting nodes in WLI-nets

(IP or R2R networks).

P111 and P112 are identical and connected in parallel. One of the connectors are

intended to be used from the previous node, and the other connector to the next node in

the network. Either of P111 or P112 can be used for the first and the last unit in the net

chain.

P113 – Batteries

P113 is a 2 pole male connector used for the on-board backup batteries.

P114 – Backup power output

This jumper sets the backup power output state. The OFF state is shown in the figure

(the pins closest to the battery pack interconnected).

This jumper has to be in the OFF state when used in an OCM unit. Otherwise, it shall be

in the ON state (opposite to the figure).

P115 – Future port

P115 is a 3 pole male connector intended for future use (not used for the time being).

P130 – RCC port

P130 is a 34 pole 2 line male connector used for connecting an RCC, Remote

Communication Control unit.

The P130 connector contains both the modem connection and RCC power supply.

33 34