User's Manual

044-05117
Network Link Budget
RF carrier power (each TRX) at BTS top connector (in dBm)?
Desired RF carrier power (each TRX) at power amplifier cabinet output connector (in dBm)?
Current system uplink and downlink balance or difference?
Is discontinuous transmit (DTX) feature used?
Power
AC Voltage available for power amplifier at site:
Vac;
Amps
Singe Phase or Three Phase? (circle one)
Main Panel or Sub Panel? (circle one)
Required RF Jumpers (8x8x8 configuration)
9 pieces Type N male to Type N male, ½” Heliax jumper - BTS top to power amplifier cabinet
input
Length:
6 pieces 7/16 DIN male to 7/16 DIN male, ½” Heliax jumper - power amplifier cabinet output
to antenna feedline
Length:
Other? (Type & Length)
Required Cables (non-RF)
AC wiring from panel to power amplifier cabinet. Length:
Interconnecting alarm wire and connection. Length:
Ground bus wiring and attachment. Length:
Host is Responsible for
• Installing power mains panel
• Contractor management of cabinet mounting, installation and coax seal weatherproofing.
• Location preparation: structural analysis, platform installation, building code conformance,
site security
Photos Required
• BTS top connection
• BTS front inside showing TRX unit and number of TRX
• Wide view of BTS and proposed power amplifier cabinet location in same photo
• Proposed power amplifier cabinet location shown with a 1 meter long ruler in view nearby
A2-2 Installation and Service Manual - G3L-850-135 Multi-Carrier Power Amplifier