User's Manual

044-05117
Table 2-4. 4-Way Combining Averaged Heat Loading
Amplifier
Power
No. Of
Amplifiers
3-Sector (70%)
Averaged
BTU/hour
2-Sector (80%)
Averaged
BTU/hour
1-Sector (90%)
Averaged
BTU/hour
100%
Typical
BTU/Hour
120 12 28,791 32,793
120 8 19,194 20,638 21,862
120 4 9,597 10,319 10,514 10,931
120 1 2,399 2,580 2,629 2,733
* typical, based on given % of output power
Table 2-5. 4-In/4-Out Non-combining Averaged Heat Loading
Amplifier
Power
No. Of
Amplifiers
3-Sector (70%)
Averaged
BTU/hour
2-Sector (80%)
Averaged
BTU/hour
1-Sector (90%)
Averaged
BTU/hour
100%
Typical
BTU/Hour
120 4 9,585 10,585
120 3 7,198 7,739 8,198
120 2 4,799 5,160 5,257 5,465
120 1 2,399 2,580 2,629 2,733
* typical, based on given % of output power
2-5 Unpacking and Inspection
This equipment has been operated, tested, and calibrated at the factory. Only in the event of
severe shocks or other mistreatment should any substantial readjustment be required. Carefully
unpack each piece of equipment
after it has reached the installation site and is approximately in
place. Carefully open the several amplifier system containers and remove the contents. Inventory
all items to ensure all needed materials have been delivered.
Retain all packing material to support any claim of shipping damage or for use in the event that
the equipment must be returned to the factory.
CAUTION
Exercise care in handling equipment during inspection to prevent damage
caused by rough or careless handling. Some components are heavy. Follow
the guidelines set forth in Paragraph 1-5.1 when lifting heavy components.
Visually inspect the Amplifier for damage that may have occurred during shipment. Check for
evidence of water damage, bent or warped chassis, loose screws or nuts, or extraneous packing
material in the connectors or fans. Inspect male connectors on modules and harnesses for bent
connector pins.
Perform the following steps:
1. Visually inspect the MCPA for damage that may have occurred during shipment.
2. Check for evidence of water damage, bent or warped chassis, loose screws or nuts, or
extraneous packing material in the connector(s).
Installation and Service Manual - G3L-850-135 Multi-Carrier Power Amplifier 2-3