User's Manual

044-05156 Rev C 18
Fan
Module
Main
Bus
4 KW (148 Amp)
Rectifier
930-00018-005
Line
Line
GND
4 KW (148 Amp)
Rectifier
930-00018-005
Line
Line
GND
4 KW (148 Amp)
Rectifier
930-00018-005
Line
Line
GND
4 KW (148 Amp)
Rectifier
930-00018-005
Line
Line
GND
4 KW (148 Amp)
Rectifier
930-00018-005
Line
Line
GND
04-0064W-C
30 A CB 3
Rectifier 1
20 A CB 6
Surge Pro.
30 A CB 7
Rectifier 4
30 A CB 8
Rectifier 5
15 A CB 9
Battery Heater
15 A CB 2 GFCI
GFCI
Outlet
AC Relay
Surge
Protector
Battery Heater
Line
Line
EMI Filter
Line
150 A Main
CB 1
30 A CB 4
Rectifier 2
30 A CB 5
Rectifier 3
28
29
26
25
23
22
18, 21
4
7
8
10
11
13
14
4
Load
Line
BLK
GRN
9
7
8
2
12
10
11
15
13
14
24
22
23
27
25
26
5
1
6 5 4
3 2 1
B A
9 8 7
21
BLK
BLK
GRN
BLK
6
20
WHT
WHT
5
19
30, 31
WHT
BLK
GRN
Batt
Door
N/O
N/C
COM
AC
Door
N/O
N/C
COM
Rear
Door
N/O
N/C
COM
Front
Door
N/O
N/C
COM
F1
F2
F3
F4
47, 48
Light 1
Light 2
43
44
43
44
GRN
49
WHT
50
46
45
45,
46
30
29
31
17
BLK
Ground Bus
9
6
12
15
24
27
3
Neutral
Bus
Neu
Line
17
19
Neutral
Bus
*61
GND
Customer
AC Input
*Ground Warning
When connecting to the main service transformer, connect main ground and wire #61 to the Neutral bus.
When connecting to another AC panel, this becomes a sub-panel. Connect main ground to the Ground Bus and disconnect wire #61 at
the Neutral bus. Insulate the bare wires on #61 wire. Failure to disconnect wire #61 may cause a ground loop and a safety hazard,
resulting in injury or equipment damage.
Surge
Protector
SIM
33
BLK
32
BLK
16, 20
34
RED
1
28
2
2
1
18
16
NH
G
NH
S2
N/O
N/C
COM
48
50
S1
N/O
N/C
COM
47
49
Front
Rear
38
36 40
42
37
35 39
41
34
2 RED
1 BLU
3 WHT
4 YEL
2 RED
1 BLU
3 WHT
4 YEL
2 RED
1 BLU
3 WHT
4 YEL
2 RED
1 BLU
3 WHT
4 YEL
To
SIM
To Fan
Module
4.2 AC Power Distribution
Simplexed transmit RF input is provided by the BTS to the OPAF input bulkhead. The transmit signals are
combined (in the 16x16 configuration), amplified, then duplexed with the receive signals. The duplexed signals are
presented to a bulkhead connector for interface with the antenna port. The duplexer provides coupled samples of
the forward and reflected signals for BTS diagnostics.
Received signals from the duplexed antenna are separated from the transmit signals in the DLNA. The receive
signals are amplified by 45 dB through a low noise amplifier. The output signal is split into two paths, to allow for
future system expansion. Each sector has two DLNAs, one for the primary receive path and one for the diversity
receive path. The diversity DLNA only has transmit signals when the sector is expanded beyond eight carriers.
The SIM assembly monitors the MCPAs, LNAs, LVD, and rectifiers, and reports alarms via the I
2
C and DALI
interface.