User's Guide Power Supply 9170

Battery Cabinet Installation
21
Powerware
®
9170 User's Guide  LTM-1344 B Uncontrolled Copy

+
Figure 17. Battery Cable Installed in Battery Cabinet
17. Secure the +, the , and the conductors to the proper
compression lugs on the battery cabinet backplane as shown in
Figure 17. Torque all three compression lugs to 7585 in lb
(8.59.6 Nm).
18. If an additional battery cabinet will be connected to the first, in
a daisy-chain configuration, use another external battery
cabinet cable assembly for the connections between the battery
cabinets.
19. Locate the daisy-chained cable on the rear of the first battery
cabinet in the section below the location of the first cable
assembly. Follow this procedure for connecting any additional
daisy-chained battery cabinets.
20. Install the remaining cabinet rear panels using the original
screws.
21. If your UPS is a hardwired unit, continue to Electrical
Installation" on page 23. If you have a plug-receptacle unit,
skip to UPS Startup" on page 49.