Owner's manual

INSTALLATION

EATON Powerware

9135 Two−in−One UPS (5000/6000 VA) User’s Guide S 164201726 Rev 1

www.powerware.com

Installing the Rail Kit

C A U T I O N

S DO NOT install the UPS or EBM in a hermetically−closed environment without any

exchange of air.

S The UPS and EBM are heavy (see page 65): 1) Eaton strongly recommends to remove the

battery tray from the UPS before lifting. 2) A minimum of two people are required to lift

the cabinets into the rack.

NOTE The rails and the necessary mounting hardware are supplied by Eaton.

To install the rail kit:

1. Adjust the UPS control panel orientation by slightly pulling out the

control panel and rotating it 90° counterclockwise (see Figure 4).

Figure 4. Adjusting the UPS Control Panel Orientation