User's Guide Power Supply 5115

Installation
5
Powerware
®
5115 User’s Guide www.powerware.com
Press the ON button
(on the front panel)
1
11
1
Connect communication
cable from computer to
UPS (optional)
Connect UPS to power
2
22
2 & 3
33
3
4
44
4
Connect equipment to UPS
5
55
5
Thisisa typicalsetup;
yoursetup may vary.
NOTE
Figure 2.Typical UPSInstallation (120VModel Shown)
3. Plug the UPS power cord into a power outlet.
4. Plug the equipment to be protected into the UPS output
receptacles.
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
5. Start the UPS by pressing the
button as shown in Figure 2.
The
indicator illuminates indicating that power is available
from the UPS output receptacles.
The UPS conducts a self-test and enters Normal mode.If the
alarm beeps or a UPS alarm indicator stays on, see Table 9 on
page 28.
The installation is complete. To learn how to operate the UPS,
see “Operation” on page 11.
NOTE The batterieschargeto 90% capacityin approximately3 hours.However, itis
recommendedthatthebatterieschargefor6to 24hoursafterinstallationorlong-term
storage.