User Manual

1.Take out the aircraft, the battery, the base and the remote controller/ base station from the pack-
age, and place the aircraft on the base.
2.Release the buckles at the end of the arms to open the four arms in turn.
3.Open the aircraft’s top cover to place the battery into the body and fasten the cover.
4.Remove the lower cover (otherwise, it will damage the 3-axis gimbal when it is powered on and
initialized).
5.Press once quickly, then again and hold down the power button to power on the aircraft. Wait for
the complete initialization of the aircraft. (LED ashing).
6.Press the power button three times in quick succession to deploy the landing gear.
7.Place the aircraft on a at, open ground surface with the user facing the tail.
8.Connect the remote controller - Base station – Device.
Remote Controller
Standard remote controller – Insert the base station in the support for the standard remote control-
ler. Connect the standard remote controller - base station through a data cable. Fix the Device in the
holder on the surface of the base station.
Gesture-based remote controller - Use the data cable to connect the gesture-based remote control-
ler - the base station. Fix the Device in the holder on the surface of the base station.
Start with the base station/remote controller. Connect the Device to PowerVision_GroundX WIFI.
Open the mobile end Vision +, to enter the initialization state (The remote controller in N mode and
E mode without GPS signal will send an alarm. For indoor use, it is recommended to switch the
standard remote controller to P mode)
Basic Flight
9.Wait for Vision + initialization to complete, and then the APP interface displays “Device connect-
ed”. Click “Start Flying” to enter the control interface of Vision +, and the APP interface displays the
aircraft’s status data, ight mode and other information.
10.Wait for the aircraft status indicator to slowly ash yellow or green, which indicates the aircraft
is ready.
11.When the Easy mode on the standard remote controller or the gesture-based remote control-
ler is used, GPS positioning is required, and the green indicator of the remote controller is lit on.
12.Use the remote controller to start the motor and keep it idling.
13.When the aircraft’s green light slowly ashes, automatic take-o mode can be used.
14.You can also use the remote controller by slowly pushing the Ascend/Descend joystick, to
56
take-o.
15.If descending is needed, slowly pull down the Ascend/Descend joystick, so that the aircraft slowly
and steadily lands on the ground.
16.After landing, pull the Ascend/Descend joystick to its lowest position and hold for more than two
seconds until the motor is shut down.
17.After shutdown, rst turn o the aircraft and then the remote controller.