Spec Data Sheet

Doc. No. :SPE070W1D1-4 v.1x Rev. No. : 0.1 Page : 27/29

This specification data sheet is an intellectual property of PowerView Display Corporation. Any copy, reproduction

or modification without written permission of PowerView Display Corporation is not allowed.

PowerView Display Corporation, http://www.powerview.com.tw

Note (3): Adjacent-dot defect should be observed under any one of

white/Black/Green/Blue/Red pattern. 1 pair of bright dots equals 2 dots.

*Inspection patterns:

Standard inspection patterns of dot defect are listed below. PowerView uses these

patterns as standard criteria for judging dot defect. Please inform PowerView if any other

pattern is to be used to examine dot defect.

Test Pattern Defect

Black For white dot(s)

White For black dot(s)

Monotone Red/Green/Blue For black and white dot(s)

Note (4): The general mura symptoms has to be judged using 2% ND Filter.

Note (5): The inspection method of ND Filter - holding ND filter in front of the panel around

1 cm and examine the panel from 35±5 cm in the front view for 3 seconds.

Note (6): Definition of distance between dots as following illustrations.

Distance between defect dots:

Dot Defeat