Instruction Manual
9
machining marks are sll present. Should
funcon properly.
c) Heavily used side gear (Figure 5). Note that
the tooth surface is highly polished and that
the side of the tooth near the top is rolled
somewhat aer. Will not funcon—should
replaced.
3. Inspect the pinion sha(s) for any galled areas or
grooves. If they are not in excellent condion, obtain new ones.
4. Inspect the side gear thrust washers. They are im-
portant to the correct posioning of the LOCK-RIGHT parts. If
they are excessively worn or are cracked, obtain new ones.
5. Inspect the case for any chips, cracks or similar dam-
age. Also inspect the bearings. If the case or bearings look bad,
replace them. However, if you do, remember that the marked
bearing adjuster posions no longer will be correct; the ring and
pinion backlash and bearings pre-load will to be reset with a dial
indicator as described in the shop manual.
Figure 5
Heavily used side gear. Note high polish, shape