Owner manual
6
Figure 2
Mark carrier, caps, adjusters at lock hole
Removal of the Dierenal Case from the Carrier
1. Remove the third member from the vehicle as de-
scribed in the shop manual. Follow all safety precauons.
2. Check to be sure that the third member is in good
condion and that nothing is loose, worn or scored. Rock the
ring gear back and forth to get a “feel” for the backlash and check
to see that it appears to be set up properly. If any out-of-spec
condions exist, be sure to correct them before subsequent
re-assembly.
NOTE: The third member itself can be disassembled
and re-assembled without changing the ring and pinion sengs
if you are careful. Follow these steps in detail.
3. Mark everything! Don’t touch a bolt unl you have
done so. The easiest tool to use is a center punch. We suggest
placing the whole assembly upright (the same posion as when
in the vehicle), looking at the ring gear end.